GET OVERSKY NAZE32 B Flight Controller Board Insert DSM2 Receiver with Barometer For RC Multicopter Quadcopter NOW

OVERSKY NAZE32 B Flight Controller Board Insert DSM2 Receiver with Barometer For RC Multicopter Quadcopter

OVERSKY NAZE32 B Flight Controller Board Insert DSM2 Receiver with Barometer For RC Multicopter Quadcopter

Feature: Come with DSM2 compatible for 7CH receiver sensor on it is MPU6050 Basis of the original NAZE 32 MX NANO OVERSKY 32 supports both Baseflight firmware and Cleanflight firmware for using on different models MX NANO With Barometer Specifications: Working voltage:Type X: 3.3-4.5V or 5-10V
12M/10PPM Crystal Oscillator
Receivers it supports: PPM DSM2 DSMX SBUS
Option for integrated with DSM2 compatible 7CH receiver
Type X is with DCDC boost (output 5V/500mA) it can supply power for outside device
The integrated output 5V/500mA LDO can supply power for outside device
Independent ports for IIC GPS PPM/DSM/SBUS receivers
Size: 35*24*10mm Net weight: 8g LED lights meaning: Red LED-power
blue LED-flying mode
green LED-unlock How to connect a receiver: Type A type B and type C all gets a RX-S port (1.25mm 3P) which is special for connecting an outside receiver it supports signal input of PPM DSM2/DSMX SBUS (note 1) it also support 3.3V or VIN output (Note 2) in order to connect an outside receiver short connecting pads on RX-S and changing type of receiver on GUI at the same time is the way
Besides type A type B and type X all supports integrated DSM2 compatible 7CH receiver (Note 2) Notes: 1) Type A and type B doesn't support signal reverse but type X supports
2) When output is VIN and VIN>
5.5V please make sure if the outside receiver supports 5.5V or more or the outside receiver may be burnt
3) As it gets an integrated receiver as soon as the integrated receiver is set to output banned (RF circuit of the integrated receiver won't work at the moment) the outside receiver can work without problem
Binding operation: 1) Press the binding switch on the receiver (green LED is on) then power FC board release the binding switch the green LED on the receiver flashes quickly (the receiver enters binding mode)
2) Press the binding switch on the DSM2 transmitter and then turn on the power
3) When the fast flashing LED on the receiver is off and then comes to bright constantly it indicates the binding is succeed or repeat the above process
Unlock operation: Throttle to THR Elevator to PITCH Aileron to ROLL Rudder to YAW Unlocking: pull the throttle to the lowest turn YAW to the right end (if it is still unlocking please set range of YAW and THR to 120% and check the channel direction and then try) Package Included: 1 x Flight controller 4 x cables

If You search RC Helicopter then OVERSKY NAZE32 B Flight Controller Board Insert DSM2 Receiver with Barometer For RC Multicopter Quadcopter is best choice, Buy it now for Price is 141.99

Komentar